No products in the cart.
Roll over image to zoom in
Click to open expanded view
Microphone Rode VideoMic Go Video Camera Mic Recorder Handheld Wired 3.5 mm for Canon Nikon Sony DV DSLR 600D 70D D90 D3S
DSLR Microphone Rode VideoMic Go Video Camera Microphone for Canon Nikon Sony Microphone Rode Go Rycote Video Mic
The VideoMic GO is a directional microphone. It utilizes a supercardioid polar pattern to attenuate sounds from the sides, resulting in a signal that sounds closer to the camera, even when shooting in noisy environments or at moderate distances. The integrated shoe mount provides a 3/8″ thread for additional mounting options. A foam windshield and 7.9″ dual mono 3.5mm coiled output cable.
The VideoMic GO is compatible with the Nikon D4, D800, D600, D7100, D5200, D5100, D3200, Coolpix A, P7800, Nikon1 V2. It is also compatible with the Canon T2i, T3i, T4i, T5i, 60D, 70D, 7D, 6D, 5D Mk II, and 5D Mk III.
It is not compatible with the Nikon D7000.
At only 2.6 ounces, the VideoMic GO is ideal for run-and-gun HDSLR recording without the additional weight of larger on-camera microphone options.
Integrated Rycote Lyre Shock Mount
Constructed from a single piece of hard-wearing thermoplastic, the Lyre provides superior acoustic suspension to traditional elastic solutions, and won’t wear out, sag, snap, or require any rethreading to maintain its effectiveness.
No Battery Needed
The VideoMic Go does not require batteries for operation, but instead uses the plug-in power supplied via your camera’s 3.5mm microphone input. Simply plug in, and you’re ready to record.
Reinforced ABS construction
Integrated shoe mount with 3/8″ thread
3.5mm TRS mini-jack audio output connection
Acoustic Principle : Line-gradient
Polar Pattern : Super-cardioid
Frequency Response : 100 to 16000 Hz
Sensitivity : -35 dB re 1V/Pa (17.8 V @ 94 dB SPL) +/-2 dB @ 1 kHz
Equivalent Noise : 34 dBA SPL (A-weighted per IEC651)
Signal-to-Noise Ratio : 60 dBA SPL (A-weighted per IEC651)
Dynamic Range (Typical) : 96 dB (per IEC651)
Maximum SPL : 120 dB (@ 1 kHz 1% into 1 kΩ load)
Power Requirement : Plug-in power required (330 uA @ 2.5 V)
Output Connection : 3.5 mm TRS mini-jack (dual mono)
Dimensions (LxHxD) : 6.6 x 3.1 x 2.8″ (16.7 x 7.9 x 7.0 cm)
Weight ; 2.6 oz (73.0 g)
Packaging including :
1 x Videomic Go Shotgun Microphone